Removed from this pinch point of the hammer. If this is the case, a slight amount of metal can be Misfiring, as the hammer can be slowed down right at the instant required for Short or the hammer notch is slightly deep. Hammer and new mainsprings that miss-match if the mainspring tab is slightly It is possible to find a combination of the Overly long it is about impossible to get the hammer into position under tension Longer than originals to be sure they function, but there is a fine line here in that if the leg is Mainspring, is to check to see that there is clearance between the hammer pivotīoss and the mainspring behind the leg. One thing to note is that when fitting a new The our above parts are made off dimensions from original parts, as no factory 050 shorter than 12ga to the 'Vee',ģ50,026 & above 12ga Single Barrel Trap 300 Type 1/2/3 Mainsprings use the same spring& are. Springs, or even retrofitted with complete coil springs. That had broken top levers that were retrofitted with later top lever Production, 1975 & 1976, used coil type mainsprings, ejector Information we can come up with is that possibly the last 2 years of Lever shaft, while the longer notched tail snaps behind the RH receiver Lays on top of the locking block, in front of the top lever shaft, & & the anchor hole uses the cross-pin hole in the receiver at the RHĥ43,619 -to coil 12ga Superior Grade (close to lastĢ8ga, & 410 Type 3 #2224-20-T3 is. Top lever spring lays on the RH side of the receiver (inside the stock) Starting serial numbers are on the above models, and suspect they may haveĪctually been integrated with Miroku's existing numbersīasically the came but shorter OAL & not as tall, top bottom, #2224-20-T1 & on top of the lower tang, above & in front of the trigger & is pinned into the Guns, however the single barrel trap guns are essentially an O/U with the bottomįOR OUR PURPOSES, UNTIL WE FIND MORE INFORMATION, WEĪS #2224-12-T1, #2224 -12-T2, #2224 -12-T3, #2224-20-T1, ETC. These coil springs proved quite a bit more reliable.

Springs for the mainsprings, ejector hammers and the top lever springs.

Illustrated parts listing, no one has found it. Then later when the 3rd and 4th type came along, if there is an Type 1 and type 2, but differentiate only, Old Style or New Style and the They used the same part number for both the Springs are used, however in the only old parts catalog we can find, it isĪpparently for the type 2. Also sold under the name, CHARLES DALY made in JAPAN

Browning citori serial number lookup